Sauder HomePlus 411963 - Page 6

Step 2
å
Fasten the ENDS (A and B) to the TOP (C). Tighten four
TWIST-LOCK® FASTENERS.
å
Fasten the TOP MOLDING (J) to the TOP (C). Tighten two
TWIST-LOCK® FASTENERS.
411963 www.sauder.com/servicesPage 6
B
Edge with
TWIST-LOCK®
FASTENERS
C
A
J
How to use the SAUDER TWIST-LOCK
®
FASTENER
1. Insert the dowel end of the FASTENER into the hole of
the adjoining part.
NOTE: The dowel end of the FASTENER must remain
fully inserted in the hole of the adjoining part while
locking the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as
tight as possible.
Dowel end
Long fi nished edge
Wide edge
Finished
surface