Sauder Summit Station 425014 - Page 28

Step 23
425014 www.sauder.com/servicePage 28
With the palm of
your hand, tap
the DRAWER
BOTTOM down
into the groove.
VIEW THE T-LOCK BOX VIDEO
å
Fasten the DRAWER BACK (D78) to the DRAWER SIDES (D14 and D15). Use
four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D716) inserts into the groove of the
DRAWER BACK (D78).
12
3
å
Insert the DRAWER SIDES (D14 and D15) at an angle
into the slot at each end of the DRAWER FRONT (F).
å
Slide the DRAWER BOTTOM (D716) into the
grooves in the DRAWER SIDES (D14 and D15) and
DRAWER FRONT (F).
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
Groove
30S
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
F
D15
D15
D15
D14
D14
D14
F
D78
Unfi nished
surface
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
D716
D716