Sauder Transit 414417 - Step 2: Attach Extension Rails; Separate Slides and Rails; Fasten Rails to Lower End; Secure Extension Rail Cartridge

Step 2
å
Separate the EXTENSION SLIDES (AA) from the
EXTENSION RAILS (Z) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (Z) to the LOWER END (A)
and CENTER UPRIGHT (D). Use four GOLD 5/16" FLAT
HEAD SCREWS (3S) through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the END and UPRIGHT. Turn
a SCREW into this hole.
414417 www.sauder.com/servicesPage 6
Push the black lever in and pull the SLIDE from the RAIL.
A
D
Z
AA
Z
Z
Surface with
HIDDEN CAMS
Surface without
HIDDEN CAMS
1
2
3
3
2
1
Remember:
Righty tighty.
Lefty loosey.
Finished edge
Finished edge
Open end
Open end
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
3S