Sauder Trestle 424128 - Page 9

Step 4
Open end
Open end
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
3S
Finished edge
Finished edge
Remember:
Righty tighty.
Lefty loosey.
Push the black lever in and pull the SLIDE from the RAIL.
35MA35MC
1
2
3
3
2
1
424128www.sauder.com/services
Page 9
å
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as
shown in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten two EXTENSION RAILS (35MA) to a LOWER END (C2 and D2). Use four
GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the
enlarged diagram. Then, slide the inner cartridge of the EXTENSION RAIL out to fi nd
the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
å
Repeat this step for the remaining LOWER ENDS (C2 and D2).
C2 x 2
D2 x 2