Need help?Do you have a question about the sauermann Si-83 Series and is the answer not in the manual?
Connect the pump to the mains network, identifying a protective earth terminal.
Connect the high level safety switch with a dry contact NC to the mains network as per local wiring rules.
Connect condensate drain pipe to inlet holes, attach discharge tube to check valve, and use adaptor if needed.
Install the pump on ground, wall, or ceiling; ensure ventilation and check discharge tubing.
Pour water into the pump, check start/stop operation, and test safety switch by pouring more water.
Disconnect power, clean inside pump with mild solution, check float, and re-install tank.
The warranty period for the pump is 2 years.
General| Pump Type | Centrifugal |
|---|---|
| Operating Temperature | 0°C to +40°C |
| Power Supply | 230V~ 50/60Hz |
| Protection | IP44 |
| Protection Class | IP44 |
To Next Page
