SCADAmetrics EtherMeter EM-100 - Auxiliary I;O, Interface, and Protocol Setup

45
AUX I/O SETUP
SELECTIONS
DEFAULTS
SET AUX1
DIN, DOUT, PWRSAVHI, PWRSAVLO
DIN:
• DIGITAL INPUT – MAY BE MONITORED BY INTERROGATION FROM
MODBUS, DF1, ETHERNET/IP, OR ADAM MASTER
DOUT:
• DIGITAL OUTPUT – FOLLOWS COMMANDS FROM MODBUS OR DF1
(OR ADAM) MASTER
PWRSAVHI:
• DIGITAL OUTPUT GOES “HI” (5V) TO TURN ON CONNECTED RADIO
OR MODEM.
PWRSAVLO:
• DIGITAL OUTPUT GOES “LO” (0V) TO TURN ON CONNECTED RADIO
OR MODEM.
(FOR PWRSAVLO AND PWRSAVHI TIMING DIAGRAMS, SEE SECTION 9,
RADIO INTERFACE.)
DIN
SET AUX2
DOUT, DIN, DUP
DOUT:
• DIGITAL OUTPUT – FOLLOWS COMMANDS FROM MODBUS, DF1,
ETHERNET/IP, OR ADAM MASTER
DIN:
• DIGITAL INPUT – MAY BE MONITORED BY INTERROGATION FROM
MODBUS, DF1, ETHERNET/IP, OR ADAM MASTER
DUP:
• CONTROL DUPLEXER OUTPUT – FOR SDA, SDAW, RRFD, RRFW.
DIN
SET AUX3
DOUT, DIN, DUP
DOUT:
• DIGITAL OUTPUT – FOLLOWS COMMANDS FROM MODBUS, DF1,
ETHERNET/IP, OR ADAM MASTER
DIN:
• DIGITAL INPUT – MAY BE MONITORED BY INTERROGATION FROM
MODBUS, DF1, ETHERNET/IP, OR ADAM MASTER
DUP:
• CONTROL DUPLEXER OUTPUT – FOR SDA, SDAW, RRFD, RRFW
RRF
SET ONTIME
N (secs)
• USED WHEN DOUT1=PWRSAVHI OR PWRSAVLO
• TIME TO LEAVE RADIO ON AFTER THE RECEIPT OF A POLL
REQUEST
ADDRESSED TO THIS DEVICE.
• FOR TIMING DIAGRAM, SEE SECTION 9, RADIO INTERFACE.
60
(1 min)
SET OFFTIME
N (secs)
• AFTER RECEIPT OF POLL REQUEST AND AFTER ONTIME ELAPSED,
TIME TO LEAVE RADIO OFF.
• AFTER OFFTIME ELAPSES, RADIO WILL BE TURNED OFF AND
DEVICE
WILL WAIT FOR NEXT POLL REQUEST.
• FOR TIMING DIAGRAM, SEE SECTION 9, RADIO INTERFACE.
21240
(5 hrs,54min)