SCADAmetrics EtherMeter EM-100 - Page 51

49
SET LCD15
AUTO, ON, OFF
CONTROLS LCD DISPLAY OF BANNER TEXT.
AUTO:
DISPLAYS WHEN BANNER TEXT EXISTS (WHEN BANNER TEXT HAS
BEEN ENTERED BY THE USER).
ON:
DISPLAY ACTIVE.
OFF:
SUPPRESSES DISPLAY.
AUTO
SET DESCR1
TEXT DESCRIPTION FOR THE METER ATTACHED TO CHANNEL 1 (1 TO
4 CHARACTERS, NO SPACES OR PERIODS).
1
SET DESCR2
TEXT DESCRIPTION FOR THE METER ATTACHED TO CHANNEL 2 (1 TO
4 CHARACTERS, NO SPACES OR PERIODS).
2
SET BANNER
TEXT DESCRIPTION FOR THE ETHERMETER’S
LOCATION/PURPOSE/ETC... (1 TO 32 CHARACTERS).
NOTE 1: THE BANNER TEXT ENTERED SHOULD NOT CONTAIN ANY
SPACES OR PERIODS. UNDERSCORES SHOULD BE ENTERED IN LIEU
OF SPACES WHEREVER NEEDED. THE ETHERMETER WILL
AUTOMATICALLY REPLACE THE UNDERSCORES WITH SPACES ON
THE LCD DISPLAY, WEB PAGE, AND SETUP MENU.
NOTE 2: TO CLEAR THE BANNER TEXT, TYPE: “SET BANNER<ENTER>”
<BLANK>
NOTE 1: THE UNIT EXECUTES A SOFT RESTART WHEN “REBOOT” IS ENTERED AT THE COMMAND
PROMPT.
NOTE 2: THE FACTORY DEFAULT SETTINGS ARE RESTORED WHEN “FACTORYRESET” IS ENTERED
AT THE COMMAND PROMPT.