Scag Power Equipment FREEDOM Z 52 User Manual

WWW.SCAG.COM
®
Engine Options:  Kawasaki FS600, air-cooled, twin cylinder, vertical shaft
 Kawasaki FS730, air-cooled, twin cylinder, vertical shaft
 27hp Briggs & Stratton Commercial Turf Series, air-cooled, twin cylinder,
vertical shaft
 30hp Briggs & Stratton Commercial Turf Series, air-cooled, twin cylinder,
vertical shaft
Fuel Capacity/Design:  6.5 gallon fuel tank with molded-in cupholder & storage tray
Travel Control: Twin padded steering controls with gas dampers for smooth, precise
maneuverability. Levers are adjustable.
Ground Speed:  52”: Up to 8.5mph forward, 5mph reverse
 61”” Up to 10mph forward, 5mph reverse
Main Frame Construction: Steel tube frame, full-length, fully-welded
Drive Tires:  52”: 22 x 9.5 - 12, 2-ply
 61”: 23 x 9.5 - 12, 2-ply
Caster Tires: 13 x 6 - 5, 4 ply
Caster Pivot Bearings: Sealed ball bearings
Drive System: Dual Hydro-Gear ZT-3100 (52”) or ZT-3400 (61”) integrated transaxles with
charge pumps and spin- on oil filters; steel plate oil filter guards protect filters
Mower Maintenance: “Maintenance Free” mower design has no grease points, saving you
maintenance time
Electrical System: 12 Volt battery. Bendix starter.
Engine Guard: Super-tough rear engine guard protects the engine
compartment from potential impact damage when
backing up
Specications
Mowing can be
even more fun.
(Continued)
52” & 61”
models

Scag Power Equipment FREEDOM Z 52 Specifications

General

Brand	Scag Power Equipment
Model	FREEDOM Z 52
Category	Lawn Mower
Language	English

Summary

Specifications

Engine Options

Lists Kawasaki FS600/FS730 and Briggs & Stratton 27/30hp engine options.

Fuel Capacity and Design

Features a 6.5-gallon fuel tank with integrated cupholder and storage.

Travel Control

Twin padded steering controls with adjustable gas dampers for precise maneuverability.

Ground Speed

Specifies forward speeds up to 8.5/10mph and reverse speed of 5mph.

Main Frame Construction

Constructed with a full-length, fully-welded steel tube frame.

Drive Tires

Details 2-ply tire sizes for 52" (22x9.5-12) and 61" (23x9.5-12) models.

Caster Tires

Features 4-ply caster tires measuring 13 x 6 - 5.

Caster Pivot Bearings

Equipped with sealed ball bearings for caster pivots.

Drive System

Utilizes Hydro-Gear ZT-3100/ZT-3400 transaxles with charge pumps and oil filters.

Mower Maintenance

Features a 'Maintenance Free' design with no grease points.

Electrical System

Includes a 12-volt battery and Bendix starter.

Engine Guard

Super-tough rear engine guard protects the engine compartment from impact.

Belts

Uses Kevlar cord belts that are self-adjusting and self-tightening.

Drive/Load Pulleys

Steel pulleys with protective covers to keep debris away from bearings.

Instrument Panel

Features key switch, throttle, choke, BBC switch, and digital hourmeter.

Seat

Adjustable, cushioned seat with padded arm rests and retractable seat belt.

Foot Plate

Extra-large foot plate with pierced, extruded steel tread for improved comfort and footing.

PTO - Electric Clutch

Equipped with an Ogura clutch with adjustable air-gap for enhanced durability.

Cutter Decks

Features floating, adjustable, anti-scalping deck design for 52" or 61" models.

Cutter Deck Construction

Welded steel with 7-gauge skirt, 10-gauge top, and 11-gauge reinforcement.

Cutter Deck Drive

Belt-driven system with a straight belt for long life.

Anti-Scalp

Features one roller on the left-front and two on the center-front edge.

Cutter Deck Spindles

Heavy-duty, no-maintenance spindles with cast aluminum housing and sealed bearings.

Cutter Deck Height Adjustment

Foot pedal/peg lift with self-locking mechanism for transport position.

Cutting Range

Adjustable cutting height from 1.5" to 5" in 0.25" increments.

Number of Cutter Blades

Each deck is equipped with 3 Marbain blades.

Deck Leveling

4-corner adjustment mechanisms for easy deck leveling and pitch adjustment.

Total Length

Specifies total length for 52" models (73") and 61" models (79").

Total Width (Mowing Position)

Specifies width with chute in mowing position for 52" (64.5") and 61" (73.5").

Total Width (Transport Position)

Specifies width with chute in transport position for 52" (53") and 61" (62").

Height

Specifies height for 52" (61") and 61" (61.5") models.

Weight

Weight range for the mower is 805-875 lbs.

Warranty

Details 3-yr non-commercial, 1-yr commercial mower, and 2-yr engine warranties.