Scag Power Equipment SFC30-7CV-CA

Questions and Answers

E
Eileen BlankenshipAug 8, 2025
Why is my Scag Power Equipment Lawn Mower leaving strips of uncut grass?
- M
  Michelle KeithAug 8, 2025
  Streaking, or strips of uncut grass in the cutting path, can occur for several reasons. Ensure the blades are sharp, and if they are worn, sharpen them. Also, make sure the engine is running at full RPM. Check the belt tension and adjust if the belt is slipping. Clear any grass accumulation from the underside of the deck. Slow down your ground speed to suit the conditions, and only cut when the grass is dry. If the blades are bent, replace them.
B
Brian FlowersAug 13, 2025
What to do if Scag Power Equipment Lawn Mower blades hitting dirt?
- Q
  qshannonAug 14, 2025
  If your Scag Power Equipment Lawn Mower is scalping—hitting dirt or cutting very close to the ground—several factors could be at play. Reduce your ground speed to better suit the conditions, and raise the cutting height. Changing the direction of your cut, as well as adjusting the pitch and level, may also help. Avoid cutting when the grass is wet, and ensure the grass is dry before mowing.
S
Sarah ClarkAug 18, 2025
How to fix Scag Power Equipment SFC30-7CV-CA leaving occasional blades of uncut grass?
- H
  henry61Aug 18, 2025
  Occasional blades of uncut grass (stringers) can result from several issues. First, ensure the engine is running at full RPM. Adjust your ground speed to be slower, depending on the conditions. Avoid cutting wet grass; wait until it has dried out. Sharpen the blades if they are dull or incorrectly sharpened. Clean any accumulated grass from the underside of the deck. Finally, adjust the belt tension if the belts are slipping.
K
Kendra PerezAug 23, 2025
Why is my Scag Power Equipment Lawn Mower cutting unevenly on flat ground?
- L
  Linda EvansAug 23, 2025
  An uneven cut on flat ground with your Scag Power Equipment Lawn Mower can be due to several reasons. If the lift is worn from the blade, replace it. Ensure the blade is mounted correctly with the cutting edge toward the ground. Clean any grass accumulation from the underside of the deck. Sharpen the blade if it is dull.
D
Donald MurphyAug 28, 2025
How to prevent strips of uncut grass between cutting paths with Scag Power Equipment SFC30-7CV-CA Lawn Mower?
- J
  jodymathewsAug 28, 2025
  To correct streaking—strips of uncut grass between cutting paths—with your Scag Power Equipment Lawn Mower, increase the overlap of each pass.
C
Christopher MartinSep 2, 2025
What to do if Scag Power Equipment Lawn Mower cuts unevenly on uneven ground?
- J
  James FernandezSep 2, 2025
  To address an uneven cut on uneven ground with your Scag Power Equipment Lawn Mower, you might need to reduce your ground speed, raise the cutting height, and/or change the direction of your cut.