Scag Power Equipment STCII-61V-36BV User Manual

Scag Power Equipment STCII-61V-36BV

97 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

PART NO. 03549

PRINTED 9/2023

PRINTED IN USA

© 2023

Scag Power Equipment

Division of Metalcraft of Mayville, Inc.

Congratulations on owning a Scag mower! This manual contains the operating

instructions and safety information for your Scag mower. Reading this manual

can provide you with assistance in maintenance and adjustment procedures to

keep your mower performing to maximum efciency. The specic models that

this book covers are listed on the inside cover. Before operating your machine,

please read all the information enclosed.

OPERATOR’S

MANUAL

Models: STCII-48V-22FX

STCII-48V-23CV

STCII-52V-23FX

STCII-52V-24FT

STCII-52V-25CV-EFI

STCII-52V-26FT-EFI

STCII-52V-28BV-EFI

STCII-61V-26CV-EFI

STCII-61V-26FT-EFI

STCII-61V-27FX

STCII-61V-36BV

Table of Contents

Questions and Answers:

T
Travis PattersonSep 7, 2025
What causes a sloping ridge across the width of the cutting path with my Scag Power Equipment STCII-61V-36BV Lawn Mower?
- K
  katherinemcmahonSep 7, 2025
  A sloping ridge across the cutting path can be caused by unequal tire pressures; check and adjust them. Uneven wheels can also be a factor, so check and adjust tire pressure. If the deck is mounted incorrectly, consult your authorized SCAG dealer. Additionally, the deck may not be level side-to-side; check and correct its level.
B
Brenda HernandezAug 23, 2025
What to do if my Scag Power Equipment STCII-61V-36BV leaves stringers (occasional blades of uncut grass)?
- J
  Jacob EwingAug 23, 2025
  If your lawn mower is leaving occasional blades of uncut grass, several factors could be responsible. Make sure the engine is running at full RPM. If you're moving too fast, slow down to suit the conditions. Avoid cutting wet grass, as this can also cause the issue. Ensure your blades are sharp and correctly sharpened. Also, check for grass accumulation under the deck and clean it if necessary. Slipping belts could be the cause, so adjust the belt tension.
Q
qparkerAug 25, 2025
What to do if my Scag Power Equipment STCII-61V-36BV is streaking (strips of uncut grass in cutting path)?
- C
  Cynthia EspinozaAug 26, 2025
  If your Scag Power Equipment Lawn Mower is leaving strips of uncut grass in the cutting path, it could be due to several factors. Dull or worn blades are a common cause, so start by sharpening them. Also, make sure the engine is running at full RPM. Check for a slipping belt and adjust the tension if needed. Excess grass accumulation under the deck can also cause streaking, so clean it thoroughly. Reduce your ground speed, especially if the grass is wet, and consider replacing bent blades.
J
John ThomasAug 27, 2025
What to do if Scag Power Equipment Lawn Mower is scalping (blades hitting dirt)?
- B
  Bethany TannerAug 27, 2025
  If your Scag Power Equipment Lawn Mower is scalping, meaning the blades are hitting the dirt or cutting too close to the ground, check and adjust tire pressures. Slow down your ground speed, especially in rough conditions. You might need to raise the cutting height or change the direction you're cutting. Avoid cutting wet grass. These adjustments should help prevent scalping.
V
victoriamartinezAug 27, 2025
Why is Scag Power Equipment Lawn Mower streaking (strips of uncut grass between cutting paths)?
- J
  Jeremy AllenAug 27, 2025
  If your Scag Power Equipment Lawn Mower is leaving strips of uncut grass between cutting paths, increase the overlap of each pass.
J
justinoconnorAug 29, 2025
Why is Scag Power Equipment STCII-61V-36BV leaving a sloping ridge across cutting path?
- R
  Rebecca NielsenAug 29, 2025
  If your Scag Power Equipment Lawn Mower is leaving a sloping ridge across the width of the cutting path, start by checking and adjusting the tire pressure to ensure they are equal. Uneven wheels can also cause this issue, so verify their alignment. If the problem persists, consult an authorized SCAG dealer.
I
ian08Sep 14, 2025
What to do if Scag Power Equipment Lawn Mower has step cut (ridge in center of cutting path)?
- T
  Thomas AverySep 14, 2025
  If your Scag Power Equipment Lawn Mower produces a step cut, which is a ridge in the center of the cutting path, make sure the blades are mounted evenly and adjust the pitch and level. Replace the blade if it's bent. For internal spindle or mounting issues, consult an authorized SCAG dealer.
B
Bobby KellySep 8, 2025
Why does my Scag Power Equipment Lawn Mower leave streaking strips of uncut grass between cutting paths?
- L
  Levi HicksSep 9, 2025
  Streaking, or strips of uncut grass between cutting paths, is usually due to not enough overlapping between rows. Increase the overlap of each pass to resolve this issue.
E
Erica WilliamsSep 6, 2025
Why does my Scag Power Equipment STCII-61V-36BV Lawn Mower have an uneven cut on flat ground?
- W
  Wesley GarciaSep 6, 2025
  An uneven cut on flat ground can result from several issues. The blade lift may be worn, requiring a blade replacement. Ensure the blade is mounted correctly with the cutting edge toward the ground. Grass accumulation under the deck can cause problems, so clean it. Also, too much blade angle (deck pitch) can lead to an uneven cut, so adjust the pitch and level. If the deck is mounted improperly or the spindle area is bent, consult your authorized SCAG dealer. Also, check the blade to ensure that it is sharp.
C
Craig MurphySep 3, 2025
What causes an uneven cut on flat ground with my Scag Power Equipment STCII-61V-36BV?
- L
  Lauren GoodwinSep 3, 2025
  An uneven cut on flat ground with your Scag Power Equipment Lawn Mower, resulting in a wavy, high-low appearance, scalloped cut, or rough contour, can be attributed to several factors. Check the blade for wear; if the lift is worn, replace the blade. Ensure the blade is mounted correctly with the cutting edge toward the ground. Clean the underside of the deck to remove any grass accumulation. Adjust the deck pitch and level if there is too much blade angle. Also, sharpen dull blades.

Scag Power Equipment STCII-61V-36BV Specifications

General

Brand	Scag Power Equipment
Model	STCII-61V-36BV
Category	Lawn Mower
Language	English

Related product manuals

Tiger Cat II STCII-61V-23FX

Tiger Cat II STCII-61V-29CV-EFI

Preview: STCII-48V-26MX

Preview: Tiger Cat II STCII-48V-22FS

Tiger Cat II STCII-48V-22FS

Tiger Cat II STCII-52V-22FX

Preview: Tiger Cat II STCII-48V-22FX

Tiger Cat II STCII-48V-22FX

Scag Power Equipment STC52A-23KA

Scag Power Equipment STC61V-25CV

Preview: STC48V-19KAI

Tiger Cat STC61V-27CV

Preview: TIGER CAT STC48V-22FS

TIGER CAT STC48V-22FS

Tiger Cat STC52V-27CV-SS