Combustion air
Push the button sideways. Left
position is closed and right
position is open. The air is
used for combustion and regu-
lates the output of the stove.
Wires, wheels, and rails
If the wires, wheels, or rails that lift the door
should be damaged, you can access them by
removing the side panels. Lift them up and pull
them out.
Smooth operation of your wires and wheels
requires regular maintenance with a special
grease purchased through your local authori-
sed dealer.
Handle
The door is opened by pulling up the handle.
Self-closing door (BA 1)
The stove can be delivered with a self-closing
function at the factory.
Adjustment screws
The stove has two adjustment screws on the bot-
tom that can be used for levelling the stove.
Accessories
For this model you can have the following accessories:
• Thin or thick soapstone for
the baking shelf
• Thin or thick ceramic tile for
the baking shelf
• Closed cap for the baking
shelf
• Side panels in stainless steel
• Steel floor plate
• Connection piece for fresh-air
intake
You should read this manual as well as the General Instructions for Installation before beginning the installation.
SCAN 30
Data for calculation of the chimney
Stove
model
SCAN
Connecting
adaptor
mm
1
Density of
flue gas
flow
g/s
2
Flue gas
tempera-
ture
o
C
3
Minimum
draft
Pa
4
Density of
flue gas
flow
g/s
5
Flue gas
temperature
o
C
6
Minimum
draft
Pa
7
0,8
Minimum
draft
Pa
30
150 - - - 6,5 345 14 11
With closed doorsWith open doors
Column 2 and 5 show the flue gas temperature in the connecting adaptor
Column 3 and 6 show the lowest/minimum draft in Pa by rated value
Column 7 shows the lowest/minimum draft in Pa by 0.8 x rated value
The stove can be prepared for an
external air supply where fresh air
is let directly into the combustion
chamber (must be mounted from
the factory).
To Next Page
Loading...
