General system description 2 - 12
Doc.nr : 6611-018
%$77(5<&+$5*(5$1'%$77(5<&+$5*,1*
The battery charger must
be mounted in a vibration free area inside the cab or indoors and be
protected against damp and temperature variations.
• The normal charging time for an empty uncharged battery, is approximately 12-14 hours.
• The battery charger should be connected directly to the vehicle battery to enable charging
during idle time.
• The batter charger is constructed so that no damage will occur from long continuous
charging.
• The supply voltage to the battery charger should be +11 VDC to +30 VDC.
7KHUHDUHWZRLQGLFDWLQJ/('VRQWKHEDWWHU\FKDUJHU
x 5('/(' (32:(5) : indicates supply power available ( i.e. from the vehicle battery ).
x *5((1/(' (&+$5*,1*) : indicates that charging is taking place.
A fuse-holder ( bayonet type ) is located next to the connecting cable and contains a glass fuse
3 Amp. ( quick ), size 5 x 20 mm .
3RODULW\IRUWKHFRQQHFWLQJFDEOH%OXHDQG%URZQ
7KHEDWWHU\FKDUJHUFXUUHQWZLWKRXW
EDWWHU\SDFNLV
≈
P$
7KHEDWWHU\FKDUJHUFXUUHQWZLWK
EDWWHU\SDFNLV
≈
P$
7KHWHUPLQDOYROWDJHDWWKHEDWWHU\FKDUJHUWHUPLQDOVLVDSSUR[LPDWHO\WKHVDPHDVWKHYHKLFOHEDWWHU\YROWDJH
'HIHFWLYHQRQIXQFWLRQLQJEDWWHU\FKDUJHU
If the driver is using cable control and the battery pack is in place in the control unit, the
battery will be charged automatically. See also below.
%DWWHU\FKDUJLQJYLDFDEOHFRQWUROIRUH[RYHUQLJKW (&KDUJLQJWLPHLVDSSUR[KRXUV).
Place the battery pack in the control unit (HPHUJHQF\VWRSGHSUHVVHG) and connect the cable
between the control unit and the electronicbox (HPHUJHQF\VWRSRQWKHFUDQHDFWLYDWHG
The electronicbox must be in 5HPRWH : (3RZHU, and LED 1R should blink). Battery charging is
now taking place !
To Next Page
Loading...
Need help?
General
