Why communication between Scanreco Remote Control Transmitter and Receiver cannot be established?
If communication between the Scanreco Remote Control transmitter and receiver cannot be established, it may be because the transmitter and receiver are not paired. Follow the instructions in chapter 10.2 to pair them.
What to do if pairing has no effect on Scanreco Remote Control?
If pairing of your Scanreco Remote Control has no effect, the battery in the transmitter may be low. Replace the battery in the transmitter.
What to do if Scanreco Remote Control display shows “Po-00” or “Po-Id”?
If the display on the Scanreco Remote Control receiver shows “Po-00” or “Po-Id”, set both jumpers to the “Jumper rest” position. This issue arises when a jumper inside is set to Configuration mode or Pairing mode.
How to fix Scanreco G5-CAN Remote Control transmitter that does not start?
If the Scanreco Remote Control transmitter does not start, check the batteries to ensure they are not depleted. Also, verify that the receiver is powered on by checking the receiver display.
Why is nothing shown on the Scanreco G5-CAN Remote Control receiver display?
If nothing is shown on the Scanreco Remote Control receiver display, check the power supply to ensure it is properly connected.
Why some buttons on Scanreco G5-CAN Remote Control transmitter do not work?
If some buttons on the Scanreco Remote Control transmitter do not work, check if the buttons are operational by following the instructions in chapter 12.3. Contact the machine installer to learn how to connect a button to an output, as the button may not be connected to any output.
General safety instructions and responsibilities before installation and operation.
Operator responsibilities and checks before operating the system.
Step-by-step guide for battery replacement in the G5 Pocket Transmitter.
Step-by-step guide for battery installation/replacement in the Rocket Flex Transmitter.
Description of the G5 Receiver, its construction, and protection features.
Guidelines for physically mounting the G5 Receiver unit.
Specifies recommended torque values for screws during assembly.
Procedure for establishing a secure link between transmitter and receiver.
Recommended checks for maintaining the system's integrity and performance.
General| Brand | Scanreco |
|---|---|
| Model | G5-CAN |
| Category | Remote Control |
| Language | English |
To Next Page
