Why communication between Scanreco G5 Rocket Flex System Transmitter and Receiver cannot be established?
If communication between the Scanreco Remote Control transmitter and receiver cannot be established, it may be because the transmitter and receiver are not paired. Follow the instructions in chapter 10.2 to pair them.
What to do if pairing has no effect on Scanreco G5 Rocket Flex System Remote Control?
If pairing of your Scanreco Remote Control has no effect, the battery in the transmitter may be low. Replace the battery in the transmitter.
What to do if Scanreco G5 Rocket Flex System display shows “Po-00” or “Po-Id”?
If the display on the Scanreco Remote Control receiver shows “Po-00” or “Po-Id”, set both jumpers to the “Jumper rest” position. This issue arises when a jumper inside is set to Configuration mode or Pairing mode.
How to fix Scanreco G5 Rocket Flex System Remote Control transmitter that does not start?
If the Scanreco Remote Control transmitter does not start, check the batteries to ensure they are not depleted. Also, verify that the receiver is powered on by checking the receiver display.
Why is nothing shown on the Scanreco G5 Rocket Flex System receiver display?
If nothing is shown on the Scanreco Remote Control receiver display, check the power supply to ensure it is properly connected.
Why some buttons on Scanreco Remote Control transmitter do not work?
If some buttons on the Scanreco Remote Control transmitter do not work, check if the buttons are operational by following the instructions in chapter 12.3. Contact the machine installer to learn how to connect a button to an output, as the button may not be connected to any output.
Operator responsibilities and checks required before operating the G5 system.
Instructions for installing and changing the batteries in the G5 Rocket Flex Transmitter.
Information about the battery charger for the Rocket Flex, its features and specifications.
Specific instructions on how to properly mount the G5 Receiver unit.
Step-by-step guide for securely pairing a transmitter with a G5 receiver.
General advice for operators to troubleshoot common problems with the G5 system.
A table listing common scenarios/symptoms and their potential causes and solutions.
General| Battery Life | Up to 20 hours |
|---|---|
| Enclosure Protection | IP65 |
| Power Source | Rechargeable battery |
| Communication Range | Up to 100 meters |
| Weight | 800 grams |
| Frequency | 433-434 MHz / 902-928 MHz |
To Next Page
