2.2 Pre-operational
Prior to operation, the operator must ensure that: he/she:
• is fully trained by the system installer in proper use of the application and knows all
functions available in the SCANRECO G5 system.
• is responsible to ensure that non-qualied personnel never gains control of the
SCANRECO G5 system.
• has fully understood this instruction manual.
• has fully understood the instruction manual given by the system installer.
• is well aware of the positioning of the emergency stop arrangements.
• uses the correct transmitter with the correct receiver unit.
• has at all times full view of the work area where the application is used.
• always keeps the SCANRECO G5 system deactivated if not used.
• never leaves the SCANRECO G5 system unsupervised.
• stores the SCANRECO G5 system in such a way that unauthorized personnel cannot gain
control of it.
• on a daily basis ensure that all safety related functions and emergency stop functions works
accordingly(or immediately if suspicion of malfunction).
• always report faults that may have appeared during operation to the system installer.
• is aware of, and obey, any local rules applied regarding operation of the application that
the SCANRECO G5 system is operating.
In order to ensure safety of the operator, bystanders and the machine, the user should study
and learn all provided instructions regarding how to use the SCANRECO G5 system as well as all
safety instructions and the location of all emergency stop controls. This will enable the user to
quickly get familiar with the new remote control system and how to safely utilize it.
The operator must understand and follow the below instructions at all times!
6/33
To Next Page
Loading...
Need help?
General
