Why communication between Scanreco G5-R5 Remote Control Transmitter and Receiver cannot be established?
If communication between the Scanreco Remote Control transmitter and receiver cannot be established, it may be because the transmitter and receiver are not paired. Follow the instructions in chapter 10.2 to pair them.
What to do if pairing has no effect on Scanreco Remote Control?
If pairing of your Scanreco Remote Control has no effect, the battery in the transmitter may be low. Replace the battery in the transmitter.
What to do if Scanreco G5-R5 Remote Control display shows “Po-00” or “Po-Id”?
If the display on the Scanreco Remote Control receiver shows “Po-00” or “Po-Id”, set both jumpers to the “Jumper rest” position. This issue arises when a jumper inside is set to Configuration mode or Pairing mode.
How to fix Scanreco G5-R5 Remote Control transmitter that does not start?
If the Scanreco Remote Control transmitter does not start, check the batteries to ensure they are not depleted. Also, verify that the receiver is powered on by checking the receiver display.
Why is nothing shown on the Scanreco Remote Control receiver display?
If nothing is shown on the Scanreco Remote Control receiver display, check the power supply to ensure it is properly connected.
Why some buttons on Scanreco G5-R5 transmitter do not work?
If some buttons on the Scanreco Remote Control transmitter do not work, check if the buttons are operational by following the instructions in chapter 12.3. Contact the machine installer to learn how to connect a button to an output, as the button may not be connected to any output.
Operator must understand and follow pre-operational safety checks and responsibilities.
Explanation of default settings, button functions, and configuration options for Rocket Flex.
Guide for installing or replacing rechargeable batteries in the G5 Rocket Flex Transmitter.
Information about the battery charger, its assembly, and charging specifications.
Description of the G5 Receiver, its construction, and protection features.
Technical specifications for the G5 M19 Receiver, including connectors and output loads.
Procedure for establishing a unique assignment between a Transmitter and Receiver.
Introduction to troubleshooting common problems with the Transmitter, Receiver, or radio.
General| Enclosure Protection | IP65 |
|---|---|
| Battery Life | Up to 20 hours |
| Frequency | 433-434 MHz |
| Operating Temperature | -20°C to +55°C |
| Operating Range | Up to 100 m |
To Next Page
