Scanreco G5 Rocket Flex System User Manual

12.3 Transmitter test mode
The Transmitter is equipped with a test mode to test the functionality of the buttons and
LED’s. Radio communication with the receiver is disabled while in test mode.
Simultaneously press button #1 and button #2.
LED# 2, 3 & 4 will light indicating the Transmitter
is in Test Mode. OLED display will light up and
show test screen.
Pressing any single button will illuminate LED#1.
Test all buttons one at a time to ensure they
function correctly. Firmware and serial number
will be shown in the display.
Pressing any two buttons at a time will illuminate
LED# 5. This ensures the red LED is functioning
correctly.
Releasing the red stop button will illuminate
LED#4. Pushing the red stop button will darken
LED#4. (Transmitter may restart during the
stop button release)
The Transmitter will automatically shut down if
no buttons are pressed for 10 seconds.
Pressing any 2-step button will make LED# 1
ash. Test all buttons one at a time to ensure
they function correctly.
A.
E.
C.
D.
B.
A.
B.
C.
D.
E.
F.
30/33

Scanreco G5 Rocket Flex System Specifications

General

Brand	Scanreco
Model	G5 Rocket Flex System
Category	Remote Control
Language	English