11.1 Storage
11.2 Maintenance
11.3 Cleaning
Store the G5 Transmitter and Receiver in a dry environment where it is not exposed to
unnecessary water/moist or extreme temperatures according to chapter 4.5, 5.5 and 6.4-6.6.
It is recommended that the following checks are done at regular intervals or when
suspicion of malfunction is present:
In the event of system failure, please refer to the troubleshooting chapter in this
document.
Only use a damp cloth to remove any mud, dirt, concrete or other debris from the Transmitter
and Receiver when necessary.
• Check for damage on the Transmitter and Receiver chassis. Look for cracks, cavities,
damaged gaskets or other damage that would compromise the integrity and allow
water/moist to enter inside.
• Check wiring and cables for damage that could cause interruption or
electrical disturbances.
• Check that the connector pins and the terminal block connections in the Receiver
are covered with grease suitable for electronic applications. The grease will prevent oxidation
of the connectors caused by water/humidity and will increase the life span of the unit.
We recommend GreaseWay SG 32 W grease.
IMPORTANT!
Store the unit where it is safe! It is the operator’s responsibility to ensure that
the G5 system is kept out of unauthorized personnel’s reach!
IMPORTANT!
Never conduct maintenance without disconnecting power rst! Any eventual defects
found must be reported to the system installer for proper evaluation.
ATTENTION!
Never use high-pressure to clean the Transmitter or Receiver, this will shorten the life span of the
product or in worst case damage it.
Never use acids, alcohol or thinner when cleaning the Transmitter or Receiver as it dries up gaskets,
signicantly reducing its capability to prevent water/moist ingress.
11 Product care
28/33
To Next Page
Loading...
Need help?
General
