Scanreco RC400 User Manual

Safety regulations and operating instructions 3 - 2
Doc.nr : 6611-018
23(5$7,1*,16758&7,216

%HIRUHRSHUDWLRQWKHGULYHU0867PDNHKLPVHOIDZDUHRIWKHFRQWHQWVLQWKH
6$)(7<5(*8/$7,216IRUUHPRWHO\FRQWUROOHGFUDQHV7KHGULYHUPXVWEH
DZDUHRIWKHIXQFWLRQRIDOOPDQRHXYUHOHYHUVDQGVZLWFKHV
1. For remote control: Place the electronicbox power switch into 5(027(.
For manual/emergency operation: Place the electronicbox power switch into 0$18$/.
3RZHULVQRZRQO\VXSSOLHGWRWKHGXPSYDOYHDQGWKHFUDQHVIXQFWLRQVFDQEH
PDQRHXYUHGGLUHFWO\IURPWKHYDOYHVKDQGOHYHUV

Twist up the emergency stop switches on the crane and on the control unit.
Cable operation:
Connect the control cable between the control unit and the electronics
box ( crane ).
Radio operation: Place a newly charged battery in the control unit’s battery holder.
3. Press
216,*1$/)5(46+,)7, and the red LED will light continuously.
4. The crane is now ready for operation. The driver must be aware of all manoeuvre lever and
switch functions before operation is started.
5. To switch off or to activate the emergency stop the emergency stop switches on the control
unit and crane should be pressed down. The emergency stop on the control unit should
always be in the depressed position whenever the unit is not in use. This applies even for
short stoppages, for example, if the driver wishes to move.
6. To ensure a long life for the control unit and for reasons of safety, the control unit must be
kept locked in the cab.( The control unit should be regularly wiped off with a damp cloth for example ).
hydrostat.ru

Scanreco RC400 Specifications

General

Category	Remote Control
Model	RC400
Operating Temperature	-20°C to +55°C
Power Source	Battery
Protection Class	IP65