SCANVARM LINK - Phone Book

PHONE BOOK
In order to receive alarm messages from the remote unit about temperature and power status you will need to add
telephone numbers of the receivers in the phone book. You can store up to ve receivers in the phonebook at the
same me.
FUNCTION SMS COMMAND SMS EXAMPLE
Receiver 1
T E L 1 X X X X X X X
TEL1 004411111111




Receiver 2
T E L 2 X X X X X X X
TEL2 004422222222
Receiver 3
T E L 3 X X X X X X X
TEL3 004433333333
Receiver 4
T E L 4 X X X X X X X
TEL4 004444444444
Receiver 5
T E L 5 X X X X X X X
TEL5 004455555555

For security reasons it is recommended to select one receiver in the phone book who will always receive SMS
with conrmaons when the remote unit performs executed remote commands on the heat pump. By default the
remote unit will send all conrmaons back to the same telephone number the remote commands comes from. If
you acvate this funcon you will get control over executed remote commands done by others.
FUNCTION SMS COMMAND SMS EXAMPLE
Acvate
S T E L X
STEL 3 (Receiver 3 in the phone book)



Deacvate
S T E L 0
STEL 0
PROGRAMMING
4
ENGLISH