SCANVARM LINK - Troubleshooting; Factory Reset

ERROR CODES
SMS CAUSE DELAY
AC Power - FAIL Power fail: External power supply faulty or disconnected. 15 minutes
AC Power - RESTORED Power fail: External power supply restored. 15 minutes
Baery - DISCONNECTED Baery power: Baery switched o or disconnected. 3 minutes
Baery - CONNECTED Baery power: Baery reconnected. 3 minutes
Baery - LOW Baery power: Low baery level. 3 minutes
Baery - RESTORED Baery power: High baery level. 12 hours
Temperature - LOW Temperature alert: Low temperature level. 3 minutes
Temperature - HIGH Temperature alert: High temperature level. 3 minutes
Temperature - LOW / RESTORED Temperature alert: Low temperature level restored. 3 minutes
Temperature - HIGH / RESTORED Temperature alert: High temperature level restored. 3 minutes
Operang error! Something wrong with the SMS command. 15 seconds
FACTORY RESET
1. Disconnect external power supply and switch o the baery switch under the service cover.
2. Hold down both buons on the right side of the unit at the same me as you reconnect the external power supply.
3. When all the lights on the front of the unit ash rapidly, release the buons on the side.
4. The device is now restored to factory sengs.
TROUbLESHOOTING
8
ENGLISH