WARNING!
Risk of injury by rapidly closing door
If the pull cord knob is pulled while the door is open, there is a risk that the door could close quickly
because of weak, broken, or defective springs or due to faulty counterbalance mechanism. The pull
cord should only be pulled while the door is closed.
Risk of injury during door movement
While the door is moving, the risk of injury to persons or damage to objects is increased while standing
in the movement area of the door. Keep door operator system and remote controls out of reach of
children. Ensure that when the door is moving that no persons or objects are located within the door
movement area. Only use the garage door operator when you have view of the garage door itself and
can monitor its movement. Monitor the door travel until the door has reached the end position. Drive or
pass through the garage door entryway ONLY when the door has come to a standstill! Never stand
directly under the open door.
Proper Use
Demonstrate to all persons using the door operator system the proper and safe operation of the garage
door operator. Demonstrate and test the mechanical release as well as the safety return.
6. Precautions for the use of the remote control
WARNING!
Risk of injury from unwanted or accidental door movement
Accidental pressing of a button on the remote control can lead to unwanted door movements and lead to
accidental injury. Make sure that remote controls are not accessible to children and are only used by
persons who have been instructed in the operation of the remote-controlled garage door operator
system! Only use the remote when you are in visual contact with the door unless a safety device is
connected (e.g. photocell). Drive or pass through the garage door entryway ONLY when the door has
come to a standstill! Never stand directly under the open door. Note that the accidentally pressing a key
on the remote (for example in your pocket / handbag) may lead to an unwanted door travel.
7. Safety Installations
Safety-related functions and components such as automatic power shutdown and the use of external
photocells have been tested and meet the requirements of EN 12453 and EN 12445 standards.
WARNING!
Risk of injury from malfunctioning safety devices
To test the safety reverse, hold the door as it closes with both hands. The garage door operator system
must stop and initiate the safety reverse. Test this also as the garage door opens. The door system must
switch off and stop the door movement. Upon failure of the security reverse, directly entrust an expert
with the inspection or repair.
8. Inspection and maintenance
The garage door operator is maintenance-free. According to the manufacturer and for your own safety,
we recommend that you allow the garage door operator system to be inspected by an expert. A check or
a necessary repair should only be performed by a specialist. Please also contact your supplier. A visual
inspection may be carried out by the user. Check all safety and security features on a monthly basis.
Existing errors or defects must be rectified immediately. Inspect the tension of toothed belt every six
months and adjust accordingly if necessary. During the opening and closing phase, the belt may loll
briefly because of rail profile. However, this effect does not have any technical losses and also does not
adversely affect the function and life of the belt.
To Next Page
Loading...