2.
Programming Remote Controls
NOTE: The remote controls that are supplied with the garage
door opener should be pre-programmed. If not, please follow
directions below.
a) Press the CODE button. A dot (.) will be indicated in the corner of
the display.
b) Now press the button on the remote you want to use, wait 2
seconds, then press and hold the same button on the remote
again for 2 seconds.
The dot (.) on the display will flash to confirm the code, then turn
off. Repeat the process for additional remotes that need to be
stored.
3. Deleting Stored Remote Controls
Press and hold CODE button until a C is indicated on the display. All
stored remotes will be deleted.
1. Programming Opening and Closing Limits
a) Press and hold SET button until 1 appears on the display, then
release the button.
The door opener is now in Programming Mode.
b) Press and hold the UP button until the door reaches the desired
open position.
NOTE: Fine adjustments can be made by toggling the UP & DOWN
buttons
c) Now press the SET button to confirm the position. The
display will now indicate the number 2.
d) Next press and hold the DOWN button until the door
reaches the desired closed position. For fine
adjustments toggle the UP & DOWN buttons.
e) Now press the SET button to confirm the closed position.
CAUTION: The door will now cycle the open and close
phases to set the travel limits and force sensitivity adjustments.
Upon completion, the door is ready for normal operation.
To Next Page
Loading...