CSV 409 A caravan charging system instruction manual
10
Issued: 20.02.2020 8050101 BA / EN
5.4 Operating faults
The majority of power supply system faults are caused by blown fuses.
Please contact our customer service address if you cannot eliminate the
fault using the following table.
If this is not possible, e.g. if you are abroad, you can have the caravan char-
ging system repaired at a specialist workshop. In this case you must ensure
that the warranty is not invalidated by incorrect repairs being carried out and
Schaudt GmbH will not accept any liability for damage resulting from such
repairs.
Fault Possible causes Remedy
Caravan batter
is not No mains volta
e Switch the cut-out in the
charged during 230 V
vehicle back on; check the
operation
mains voltage
Defective caravan
charging system
Call customer service
Caravan battery is not
charged whilst driving
Defective alternator Have the alternator
checked
No voltage supplied to
“Ignition ON” input or per-
Have the fuse and wiring
checked
manent plus
Check the towing vehicle
plug connection
Defective caravan
charging system
Call customer service
Solar charger is not wor- Solar charger not plugged Plug the solar charger in
king (mains supply off)
in
Defective fuse or wiring Have the fuse and wiring
checked
Defective solar charger Have the solar charger
checked
power supp
y
n
e
ma
nsw
c
s
ma
nsw
c
mus
e
living area does not work switched o
switched on
Defective fuse or wiring Have the fuse and wiring
checked
Defective caravan
charging system
Call customer service
Caravan charging system Defective caravan Call customer service
cannot be switched on
charging system
using the rocker switch
No voltage supply Check the battery or
mains connection
Defective rocker switch Call customer service
Y If the device becomes too hot due to excessive ambient temperature or
lack of ventilation, the charging current is automatically reduced. How-
ever , always prevent the device from overheating.
5.5 Shutting do wn the system
Press the rocker switch (12 V main switch) so that it is briefly in the
“OFF” position.
Flat vehicle fuses