Schaudt MP 22-T - Shutting down and Starting up after Shutting down

Instruction Manual MP 22-T Display Panel
12
Date: 28.05.2014 831.416 BA / EN
Fault RemedyPossible cause
The mains indicator does
not illuminate although the
2
3
0
V
i
l
i
The mains connection is
dead.
Check the mains supply
(e.g. camping site).
g
230V mains supply is
connected.
The power cutout to the
electrobloc has tripped or
is disabled.
Connect power cutout.
”--40” or ”60” flashes when
selecting the temperature
display
The external temperature
sensor or the connection
cable to the external
temperature sensor is
defective.
Contact customer service.
3.6 Closing down and starting up again after stopping
3.6.1 Closing down th e system
The system should be switched off if the vehicle is not going to be used for a
longer period, e.g. during the winter.
Standstill is performed in different ways depending on electrobloc used
(electrobloc with or without battery isolator on the front panel).
Standstill for electrobloc without battery isolator on the front panel (such as
EBL 220):
" Switch off display panel (see section 3.2).
" Press, and keep pressed, the ”Living Area Battery” button.
Symbols ”V” and ”A” flash three times after a certain time (approx. 10 se-
conds).
" Release the ”Living Area Battery” button.
F Battery isolation is enabled.
F All consumers are switched off.
Y The remaining standby current is lower than 8 mA (approx. 6 Ah per
month). A motorhome with a fully charged (and intact) 80 Ah living area
battery can stand for approx. 4 months without problem. For longer pe-
riods, the battery terminals should be disconnected.
Standstill for electrobloc with battery isolator on the front panel (such as
EBL 101):
" Disable battery isolator on electrobloc.
" For both cases, more detailed information on closing down the system
can be found in the EBL ... electrobloc instruction manual.