6
TECHNICAL SPECIFICATIONS:
CHARGING INSTRUCTIONS:
STEP 1 - Pre Charge Check & Electrolyte Level Check
Check the Battery Electrolyte level (Not required on sealed & Maintenance Free Batteries).
If necessary, remove the vent caps and add distilled water so the levels are halfway between
the upper and lower fill lines.
STEP 2 - Connecting the Battery charger to your Battery
If the Battery is out of the vehicle:
o Connect the Red lead from the charger to the positive (+) battery terminal.
o Connect the Black lead from the charger to the negative (-) battery terminal.
If the Battery is still in the vehicle, determine if the vehicle is positively (+) or negatively (-)
earthed.
o If Negatively Earthed (Most Common) – FIRST Connect the Red (+) battery charger
lead to the positive (+) Battery post and then connect the Black (-) battery charger
lead to the vehicle’s chassis and away from the fuel line.
To Next Page
Loading...
