Scheppach 1901507901 - User Manual

Questions and Answers

J
Jordan PhamAug 12, 2025
Why won't my Scheppach 1901507901 motor turn on?
- K
  Kevin RodriguezAug 12, 2025
  The motor might not be turning on due to several reasons: * No power: Check the mains fuse. * Defective switch or capacitor: Have a qualified electrician check it. * Defective electrical extension cord: Remove the mains fuse and check the cord; exchange it if needed. * Wrong flex 3~400V Motor: Use a 5-poled flex with a 1,5 mm² cross-section. * Housing cover open (end switch): Ensure the housing cover is closed exactly.
Y
Yolanda GallagherAug 17, 2025
What to do if Scheppach Saw leaves scorch marks on wood?
- N
  Natalie LongAug 17, 2025
  Scorch marks on wood during work can be caused by: * A dull saw band: Replace the saw band. * Using the wrong saw band: Select the correct one from the Scheppach catalogue. * Incorrect cutting speed: Adjust the cutting speed. * Longitudinal fence not parallel to saw band: Adjust the longitudinal fence.
J
James WarnerAug 23, 2025
How to fix a Scheppach Saw band that jams during work?
- D
  Dawn GlennAug 25, 2025
  If the saw band jams during work, it could be due to: * A dull saw band: Replace the saw band. * A resined saw band: Clean the saw band. * A badly adjusted guide: Readjust the guide.
A
Anthony FrankAug 29, 2025
Why does the saw band wander or jump down on my Scheppach 1901507901 Saw?
- T
  tarajohnsonAug 29, 2025
  If the saw band wanders or jumps down, check the following: * Upper band wheel: Carry out side correction. * Saw band guide: Reinstall the saw band guide. * Wrong saw band: Select the correct saw band from the Scheppach catalogue. * Longitudinal fence not parallel to saw band: Adjust the longitudinal fence.
J
Jessica StoutSep 4, 2025
How to correct the motor direction on a Scheppach 1901507901 Saw?
- K
  Kelli WashingtonSep 4, 2025
  If the motor turns in the wrong direction, it is likely due to an incorrect connection. Change the rotational direction at the CEE plug.