www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
23
11. Possible causes of failure
Troubleshooting Cause Remedy
Device does not work
No electrical voltage at the device.
Check the fuse, power cable and power
plug and have them replaced by qualied
personnel if necessary.
Cross section of the extension cable
not large enough and/or the exten-
sion cable is too long.
Use extension cables with larger cross sec-
tions and/or use shorter extension cables.
The mains voltage is lower than that
specied.
Contact the power supply company if
necessary.
The pump is frozen. Check and thaw if necessary.
The motor starts but there is
no build up of pressure
Air intake in the water inlet.
Check the supply hose and hose connec-
tion and replace if necessary.
Discharge nozzle is too large. Check and replace if necessary.
Irregular operating pressure Air intake in the water inlet.
Check the supply hose and hose connec-
tion and replace if necessary.
To Next Page
Loading...
Need help?
General
