Scheppach DS200 Translation Of The Original Manual

Maintenance
Replacing the grinding disc (Fig. 8.1, 8.2)
• Remove the sand paper (1).
• Insert the Allen key (3) into the hexagonal hole in the centre of the
grinding disc (2) and turn it clockwise to remove the damaged grin-
ding disc (2).
• Insert the new grinding disc (2) and tighten it again.
Replacing the carbon brushes
The carbon brushes are wear parts that wear out during use. The car-
bon brushes should therefore be checked regularly. To prevent damage
to the circuit, the two carbon brushes must be replaced at the same
time.
ATTENTION!
The carbon brushes may only be replaced by authorised service perso-
nnel. The device must only be used with both brushes.
Cleaning
Clean the device after each grinding process
• Regularly cleaning the device can extend its service life and reduce
the amount of repair work required.
• We recommend cleaning the connection pieces and components of
the electrical motor without water.
• The parts should be cleaned immediately after use.
• Clean the parts with a hairbrush and a dry cloth.
Service
Only have your electrical device cleaned by qualied specialised perso-
nnel and only use spare parts with identical designs. This ensures the
technical safety during use.
Storage
The device, the operating manual as well as accessories, if applicable,
must be stored in the original packaging. In this way, you will always
have all information and parts at your disposal when required. Pack the
device carefully or use the original packaging in order to prevent dama-
ge during transport. Always store the device in a dry location.
GB
17

Scheppach DS200 Specifications

General

Brand	Scheppach
Model	DS200
Category	Sander
Language	English