79
cable is a specification
DAMAGED ELECTRIC CONNECTING CABLES
Insulation damages frequently occur on electric connec-
ting cables. The reasons are:
• Pressure points, if connecting cables are routed
through window or door gaps.
• Kinks due to improper mounting or routing of connec-
ting cables.
• Intersections due to overruns of connecting cables.
• Insulation damage due to pulling out from wall so-
ckets.
• Cracks due to ageing of insulation.
Such damaged electric connecting cables should not be
used and can be fatal because of the insulation damage
AC motor 230 V/ 50 Hz
Mains voltage 230 Volt / 50 Hz.
Mains connection and extension cable must have 3-wires
= P + N + SL. - (1/N/PE).
Extension cables must have a minimum cross-section of
1.5 mm².
The mains connection is secured with a max. 16A fuse.
Maintenance
Caution! Pull out power plug.
• Clean the machine after each work cycle.
• Replace worn out cutting discs.
• Replace damaged protection device
• Dust and pollution must be removed regularly from the
machine. The best way to clean the machine is with a
piece of cloth or brush.
• All moveable parts must be re-lubricated at periodic
intervals.
• Do not use any corrosive substances to clean the plas-
tic.
• The tub (4) and coolant pump (14) must be cleaned
regularly to remove dirt, as otherwise the cooling of the
diamond cutting disc (10) is not guaranteed.
Spare-part ordering
Please quote the following in your order for spare parts:
• Type of device
• Article No. of device
• Ident. No. of device
• Spare Part No. of the required spare part
To Next Page
Loading...
Need help?
General
