85
Panne
Diamond cutting disc comes off
when motor is deactivated.
Fastening nut not tightened properly Tighten fastening nu
when motor is deactivated. a) Failure of mains circuit-breaker a) Check mains circuit-breaker
b) Extension cable defective b) Replace extension cable
c) Connection with motor or switch is
not OK
c) Have it checked by an electrician
d) Motor or switch Is defective d) Have it checked by an electrician
Motor has no output a) Cross-section of the extension cable
Is not sufcient
a) See electrical connection, the fuse
has blown
b) Overloading b) Check tool
To Next Page
Loading...