81
Leakage current circuit-breaker
ADDITIONAL INSTRUCTIONS
FOR LEAKAGE CURRENT CIRCUIT-BREAKER.
Please observe the following important instructions on
start-up and handling.
Pay attention to the instructions even if you hand over the
product to a third party. Preserve this operating Instruc-
tions manual for subsequent reference.
SAFETY INSTRUCTIONS!
• Arbitrary alteration and/or modification of the product
is not allowed for safety- and approval reasons (CE).
Never dismantle the product.
• The product is not suitable for handling by children.
Children cannot assess the risks involved in handling
electrical devices. Therefore, pay special attention to
the presence of children.
• The structure of the product corresponds to Protec-
tion Class 1. Only a proper mains socket with an earth
wire (230V~/50Hz) of the public power supply should
be used.
• In industrial equipment, the Accident Prevention Spe-
cifications of the Federation of Trade Associations for
Electrical Systems and Resources must be observed.
• In schools, training centres, hobby- and self-help work-
shops, the operation of the product must be monitored
responsibly by trained staff.
• Handle the product carefully. Impacts, hits and drops
from even low heights can damage the machine.
• Never use the product if it is brought from a cold to a
hot room. Under certain circumstances, the resulting
condensed water can destroy the product.
• Let the product come to the room temperature, before
connecting it to the mains power supply. Under certain
circumstances, this can take several hours.
• Do not hold the product with moist or wet hands.
• Ensure that the Insulation of the entire product is neit-
her damaged nor destroyed.
• If the product is not operated over long periods, dis-
connect it from the mains power supply, pull the plug
out of the socket.
• Avoid the following environmental conditions at the
installation site or during transport:
• Wetness or very high humidity. Extreme cold. Dust or
combustible gases, vapours or solvents. Strong vib-
rations.
• Strong magnetic fields as in the vicinity of machines
or loudspeakers.
Start-up of the leakage current circuit-breaker:
• The leakage current circuit-breaker is equipped with
a test button.
• The function should be checked before each start-up
and at regular Intervals (min. once every week).
• If the leakage current circuit-breaker does not switch
off properly during this test, there is no personal pro-
tection! The device must therefore be switched off
immediately!
• In case of damages caused by the non-observation of
To Next Page
Loading...
Need help?
General
