www.scheppach.com
GB
|
25
• Check the covers and guards for damage and im-
proper attachment. If necessary, change the com-
ponents
• Keep the shredder in a dry place out of children’s
reach. Do not cover the shredder in nylon bags, as
moisture may develop
m WARNING!
Pull out the mains plug for any adjustment or repair
tasks.
Connections and Repairs
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Carbon brushes, knives
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from
our service centre. To do this, scan the QR code on
the cover page.
12. Storage
Store the device and its accessories in a dark, dry
and frost-proof place that is inaccessible to children.
The optimum storage temperature is between 5 and
30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from
dust and moisture. Store the operating manual with
the electrical tool.
13. Disposal and recycling
Notes for packaging
The packaging materials are
recyclable. Please dispose of
packaging in an environmen-
tally friendly manner.
The printing of the type designation on the connec-
tion cable is mandatory.
AC motor
• The mains voltage must be 230 V~
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm
2
.
Connections and repairs of electrical equipment may
only be carried out by an electrician.
• The product meets the requirements of
EN 61000-3-11 and is subject to special connection
conditions. This means that use of the product at
any freely selectable connection point is not allowed.
• Given unfavorable conditions in the power supply
the product can cause the voltage to uctuate tem-
porarily.
• The product is intended solely for use at connec-
tion points that have a continuous current-carrying
capacity of the mains of at least 100 A per phase.
• As the user, you are required to ensure, in consul-
tation with your electric power company if neces-
sary, that the connection point at which you wish to
operate the product meets the requirement named
above.
Connection type Y
If it is necessary to replace the mains connection ca-
ble, this must be done by the manufacturer or their
representative to avoid safety hazards.
With a single-phase a.c. motor, we recommend a C
16A or K 16A fuse for machines with a high start-up
current (from 3000 Watt)!
11. Cleaning an maintenance
Leave all work not described in this manual to
an authorised customer service centre. Only use
original parts.
Wear hand protection when working on the blade
cylinder.
Switch the shredder o, unplug it form the mains,
and wait for the blade cylinder to come to a complete
stop before working on it.
General cleaning and servicing
Do not spray water onto the shredder. Electric
shock hazard.
• Always keep the shredder, wheels and air vents
clean. Use a brush or cloth to clean it, avoid clean-
ers and solvents.
• Always check that the shredder and especially the
guards are not worn down or damaged but rmly
attached before use.
Check that the nuts, bolts and screws are tight.
To Next Page
Loading...
Need help?
General
