www.scheppach.com
40
|
GB
15. Troubleshooting
Fault Possible cause Remedy
Motor does not work Motor, cable or plug defective,
fuses burnt
Arrange for inspection of the machine by a
specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
The motor starts up
slowly and does not reach
operating speed.
Voltage too low, coils damaged,
capacitor burnt
Have an electrician check the voltage.
Arrange for inspection of the motor by a
specialist. Arrange for replacement of the
capacitor by a specialist
Motor makes excessive
noise
Coils damaged, motor defective Arrange for inspection of the motor by a
specialist
The engine does not reach
full power.
Circuits in the network are
overloaded (lamps, other motors,
etc.)
Do not use any other equipment or motors on
the same circuit
Motor overheats easily. Overloading of the motor,
insucient cooling of the motor
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Saw cut is rough or wavy Saw blade dull, tooth shape
not appropriate for the material
thickness
Re-sharpen saw blade and/or use suitable saw
blade
Workpiece pulls away and/
or splinters
Excessive cutting pressure and/or
saw blade not suitable for use
Insert suitable saw blade
To Next Page
Loading...
Need help?
General
