www.scheppach.com
GB
|
35
15. Troubleshooting
Troubleshooting
The table shows potential failures, their possible cause and solutions. However, if you are unable to solve the problem,
contact a professional to assist you.
m CAUTION!
Always switch off the engine and disconnect the ignition cable before starting any inspection or adjustment work.
m CAUTION!
If, after making an adjustment or repair to the engine, you let it run for a few minutes, remember that the exhaust pipe and
other parts will become hot. Thus, do not touch the parts that emanate heat, as these may burn you.
Important note in the case of repairs:
When returning the device for repair, please ensure for safety reasons that it is free of oil and petrol when it is sent to the
service centre.
Fault Possible cause Remedy
Machine runs unsteadily
and vibrates heavily
Screws are loose Check screws
Blade fasteners are loose Check blade fasteners
Blade is unbalanced Replace blade
Engine does not run
Engine brake lever not pressed Press engine brake lever
Throttle in wrong position Check setting
Spark plug is defective Replace spark plug
Fuel tank is empty Rell with fuel
Contaminated fuel Empty fuel tank and ll with clean fuel
Cold environment Push the primer button (if present)
Engine defective Contact authorised customer service
Engine runs unsteadily
Air lter dirty Clean the air lter
Spark plug dirty Clean the spark plug
Lawn turns yellow, uneven
mowing results
Blade is blunt Sharpen the blade
Cutting height is too low Set correct height
The discharge of grass
clippings is unclean
Cutting height is too low Set height
Blade is worn Replace the blade
Catch basket is clogged Empty the catch basket or remove the blockage
To Next Page
Loading...
Need help?
General
