Delivery contents
Planer
Cutterblock cover
Jointing fence
4 base plates
Hexagonal key SW 5
Operating instructions
Technical data
Subject to technical changes!
■ NOISE LEVELS
Sound conduction level
LWA according to EN ISO
3744
106.2 dB(A)
Uncertainty K 3 dB(A)
Sound pressure level LpA
according to EN ISO 11201
93.2 dB(A)
Uncertainty K 3 dB(A)
Note: The specied sound levels have been
determined using a standardised test proce-
dure and can be used to compare different
electronic devices. Furthermore, these values
can be used to assess in advance the strain
on the user caused by the sound.
Warning! Depending on how you use the po-
wer tool, the actual values can vary from those
stated. Take measures to protect yourself
from noise. Consider the entire work process,
i.e. even times during which the power tool
works without load or is switched off. Suitable
measures include, amongst others, regular
maintenance and care of the power tool and
the attachments, regular breaks as well as
good planning of the work processes.
The gures quoted are emission levels and
are not necessarily safe working levels. Whilst
there is a correlation between the emission
and exposure levels, this cannot be used
reliably to determine whether or not further
precautions are required. Factors that
inuence the actual level of exposure of the
workforce include the characteristics of the
work room, the other sources of noise, etc. i.e.
the number of machines and other adjacent
processes. Also the permissible exposure
level can vary from country to country. This
information, however, will enable the user of
the machine to make a better evaluation of
the hazard and risk.
■ STATEMENT CONCERNING DUST EMISSION
The values for dust emission measured
according to the “Principles for testing dust
emission (concentration parameters) from
wood processing machines” created by
the Technical Committee Wood, lie below
2 mg/m3. That means a permanently safe
compliance with the TRK threshold value for
wood dust, applicable in the Federal Republic
of Germany can be expected when the power
tool is connected to an appropriate operational
extraction unit with an air speed of at least 20
m/s.
250 310 410
Dimensions L x W x H mm
1090x510x950 1605x630x960 1680x810x960
Table height mm
830 850 850
Jointer table L x W mm
525x256 780x320 820x420
Thicknessing table L x W mm
660x247 750x307 750x408
max. thickness height
180 220 230
Weight kg
176 292 334
Cutterblock
Ø 75x250 Ø 95x310 Ø 95x410
Cutterblock ø mm
Ø 73 Ø 93 Ø 93
Cutting circle ø mm
Ø 75 Ø 93 Ø 93
Revolutions max. 1/min
4000 4400 4400
Number of planing knives
3 4 4
Planing knives
20x250x3 20x310x3 20x410x3
Feed speed m/min
5,5 6,5 6,5
Input power kW (230/400V)
2,3 / 2,3 2,5 / 2,5 3,2 / 3,6
Output power kW (230/400V)
1,7 / 1,9 2,0 / 2,1 2,4 / 2,9
Nominal current A (230/400V)
10,9 / 4,05 9,3 / 4,2 13,8 / 5,25
To Next Page
Loading...
Need help?
General
