How to fix noisy ECG traces on Schiller Medical Equipment?
To address noisy ECG traces, check the electrode contact. Ensure the patient is relaxed and warm if possible. You can also activate the myogram filter to reduce muscle tremor. Verify the mains filter setting, ensuring it matches your local power supply (50 or 60 Hz).
What to do if Schiller Medical Equipment ECG printouts are poor quality?
If you're experiencing poor quality printouts or ECG traces that are 'breaking up', clean the printhead with alcohol. Also, ensure that the paper tray cover is securely clicked into place.
Why is my Schiller Medical Equipment not printing?
If your device isn't printing, make sure the unit is connected to the mains supply. Also, check that the paper tray cover is securely clicked into place and that there is sufficient paper.
How to stop ECG trace wandering on Schiller Medical Equipment?
If the ECG trace 'wanders' away from the centre, it might be due to baseline drift. Check the electrode contact. Press the 1mV key to reset the baseline. Also, select a higher baseline frequency.
What to do if Schiller Medical Equipment does not switch on?
If the unit does not switch on and the mains indicator lamp is not lit, check if the mains cable is plugged in.
General| Brand | Schiller |
|---|---|
| Model | CARDIOVIT AT-2 |
| Category | Medical Equipment |
| Language | English |
Instructions for safe disposal and care of device batteries.
Guidelines for proper disposal of the medical unit.
Outlines the responsibilities of the physician using the ECG device.
Provides information on the manual's purpose and encourages feedback.
Explains the automatic recording function and its parameters.
Explains the manual recording function and its parameters.
Specifies environmental and placement requirements for the ECG unit.
Details the unit's power options, battery, and charging.
Instructions for powering the AT-2 unit on and off.
Guidance on connecting the unit for potential equalization.
Lists the default configuration settings for the AT-2.
Instructions on how to print the programmed settings.
Procedure to reset the unit to its basic default settings.
Describes the process for selecting the user interface language.
Details how to configure the baseline filter settings.
Explains the settings for the mains filter to suppress AC interference.
Information on setting the myogram filter for muscle tremor.
How to select lead sequences and printout formats.
How to enable or disable the acoustic QRS indication.
Instructions for setting the device's time and date.
Defines the two available formats for automatic ECG output.
Details how to set the ECG output format parameters.
Explains how to configure average cycle display in automatic mode.
How to define measurements and markings in automatic mode.
Procedure to print or suppress interpretation statements.
User settings for interpretation comments, age, and sensitivity.
How to select and define rhythm leads for printing.
Illustrates standard lead placement and provides IEC/AHA color codes.
Guidelines for cleaning and maintaining the ECG unit and cables.
Instructions for initiating and performing a self-test of the unit.
Details the required annual technical safety check for the unit.
Procedure for cleaning the thermal print head for optimal print quality.
To Next Page