GRIND - EXTERNAL
-With the SPIN section oscillating in LFO mode
plug in an external wave form and listen from
the GRIND out
-The waveforms to the right show a triangle input
in yellow and GRIND out in blue
-Each phase of the internal oscillator is compared
against and subtracted from an external signal
-If the internal oscillator is at a low frequency
the output with resemble a supersaw
-If the internal oscillator is at audio rate various
metallic overtones can be created
GRIND
KNOB POSITIONS
IN FULL CW
GRIND -> SPIN FULL CCW
DAMPING FULL CCW
To Next Page
Loading...