OPERATION
30.30.01.00174/06 www.schmalz.com EN | 33
Danger due to falling objects
- In the event of vacuum failure
- In the event of a collision, causing the load to break off
- In the event of component failure resulting from overload or
unauthorized modifications
There is a risk that people in the vicinity could be hit, causing death or serious
injury!
No person may sit or stand in the danger zone of the load.
Suitable protective equipment must be worn prior to transport.
Do not work unless you have a clear view of the entire working area.
Pay attention to other people in the working area.
Never release the control handle of the vacuum tube lifter Jumbo while lifting a
load.
Never lift loads at an angle and never drag or pull them.
Only pick up and lift suitable loads (test their intrinsic stability and porosity).
The working area must be secured by the user/operator. The
persons/equipment necessary to secure this area must be present during the
lifting/transportation process.
The maximum load must not be exceeded.
Do not set down any parts on the vacuum tube lifter Jumbo as they will fall off
when working with the vacuum tube lifter Jumbo.
Uncontrolled gripper movements
Risk of injury from the gripper jolting upward when the device is switched on or
the load becomes accidentally detached or dropped.
Never bend over the device.
Keep your distance from the device (with arms extended).
Do not use the vacuum tube lifter to free stuck loads!
The gripper must not rest on a workpiece prior to activation!
Always grip loads at their center of gravity!
Before switching on the device, move the control handle/lever to the “lower”
position.
To Next Page
Loading...
