Schnierle SL 3 - Load Limits; Notes on Disposal; Name: BA-KD-015 - Instruction Manual SL3

Instruction manual
Name:
BA-KD-015 – Instruction manual SL3
Revision:
05 – 02.01.2023
Page 13 of 13
© Copyright by Hermann Schnierle GmbH, Dieselstrasse 43, 86368 Gersthofen
4.5. Load limits
Caution
Risk of breakage due to overloading!
 Overloading could damage your seat-bench combination and cause
safety defects.
 The load limits of the respective seat-bench elements must be observed
(see below).
5. Notes on disposal
 It is generally possible to dispose your seat-bench combination via the dealer.
 If you dispose of waste yourself, please observe the disposal regulations of your
country, these may differ from the table below.
 Care must be taken to ensure that the waste is disposed of properly and in an
environmentally friendly manner.
Disposal
Packaging
Cardboard, wood
(e.g. pallet), foil
Disposal as cardboard (paper waste)/wood
waste/foil waste
Disposal of
individual
parts
Cover
Disposal as residual waste
Plastic parts and upholstery
Disposal as plastic waste (according to
labelling and type of plastic)
Metal parts
Disposal as scrap iron
Belt straps
Disposal as plastic waste – polyester
Buckle & tongue
Disposal as residual waste
Imprint:
Hermann Schnierle GmbH
Dieselstrasse 43
86368 Gersthofen
Tel: +49 821 299 930
E-Mail: info@schnierle.de
www.schnierle.de
Managing director: Martin Schnierle, HRB Augsburg 7256
The information contained in this publication corresponds to the status stated below. Hermann Schnierle GmbH reserves the right to make changes to the
technology, equipment and form of our products compared to the information in this publication as well as changes to this publication itself.