24
3. Check the function of the visor mechanism
by closing the visor once and opening it as
far as possible.
ANTI-FOG LENS
Fitting
1. Remove the visor from the helmet.
2. Use the notch to help position one side of the
anti-fog lens on one of the eccentric holding
pins. Make sure that the silicone seal is facing
the visor.
3. Carefully bend the visor just enough that
the notch is guided onto the other eccentric
holding pin on the opposite side of the anti-fog
lens. To do this, you will need to bend the end
of the anti-fog lens into a slight S-shape.
4. Check all around the anti-fog lens to
make sure that it ts tightly and evenly
against the visor. Only if this is the case
will the anti-misting properties function
properly.
C. THE HELMET
To Next Page
Loading...
