EN
65
3. Check the function of the visor mechanism
by closing the visor once and opening it as
far as possible.
ANTIFOG LENS
Fitting
1. Remove the visor from the helmet.
2. Use the notch to help position one side of the
anti-fog lens on one of the eccentric holding
pins. Make sure that the silicone seal is facing
the visor.
3. Carefully bend the visor just enough that
the notch is guided onto the other eccentric
holding pin on the opposite side of the anti-fog
lens. To do this, you will need to bend the end
of the anti-fog lens into a slight S-shape.
4. Checking the correct application of the anti-
fog lens, by trying to slide a piece of paper
between the visor and the anti-fog lens. In
case it gets between the two, please follow
point 5.
C. THE HELMET
To Next Page
Loading...
