66 67
english
Face shield (including urban position)
The face shield can be locked in any one of seven positions.
The second position (urban position) locks in place more firmly,
providing greater resistance when the face shield is in this
position. This makes it easier to lock the face shield in the urban
position, especially while riding.
When you push the face shield open, it may well travel beyond
the urban position, but it is easy to find this position by moving
it downwards again. The face shield mechanism requires no
additional lubrication. The face shield can be operated at any time
irrespective of the position of the sun visor.
Closing the face shield
To close the face shield, grip the
finger tabs at top left and right and
press the face shield down with one
movement until it audibly locks into
place.
REPLACING THE VISOR SHIELD
Changing the visor shield is easy to do without tools using the
convenient EasyChange visor mechanism. To replace the visor,
it is helpful to place the helmet on a flat surface or on your lap
while seated.
10. PINLOCK
®
VISOR
The Pinlock
®
visor is a double-wall visor that does not mist up.
The two visor plates are separated from each other and sealed
with transparent, flexible silicone. The inner visor plate is fixed
in place by eccentric pins, which pretensions the two visor plates
towards each other and creates the sealing effect. An insulating
air cushion is thus formed between the visor’s main plate –
i.e. the outer plate – and the inner plate, which prevents any
fogging up of the inner plate.
COATING
The main plate has a HighClear
®
anti-scratch coating on both
sides.
Note:
The helmet should never be used to hold gloves or any other
objects as this may damage the scratch-sensitive Pinlock
®
inner visor shield.
Note:
The Pinlock
®
inner visor is supplied with a protective film.
Remove this film before using the helmet for the first time.
Note:
The Pinlock
®
inner visor may only be used in conjunction
with the SCHUBERTH main face shield that has been specially
designed for this purpose. Other face shields must not be
fitted.
Opening the face shield
To open the face shield, use your thumb to
push the face shield up using one of the finger
tabs situated to the left and right of the face
shield, and move it to the desired position.
english
D. THE HELMET
To Next Page
Loading...
Need help?
General
