102 103
For safety reasons, only Customer Service Department should
replace non-replaceable parts of the interior lining.
3. COMMUNICATION SYSTEMS
Caution:
The installation of a communication system (including basic
headsets) constitutes a modification to the helmet. For this
reason it is necessary for any communication system and
headset intended for installation into a specific model of
helmet to be tested and approved in line with the ECE-R
22.05 European helmet standard, otherwise the helmet’s
approval and compliance with insurance requirements
become invalid on installation.
Evidence of approval in line with ECE-R 22.05 in connection
with a specific communication system is only valid if certified
by an official regulatory office of an EU member state. Any
other form of information from these or other institutions
(e.g. on the general suitability of communication systems for
use in motorcycle helmets) is of no relevance and the helmet
will lose its approval.
Your S2 is supplied ready for installation of the SCHUBERTH SRC-
System™ as standard. The S2 is already fitted with two integrated
antennas to amplify reception and a Bluetooth connection, to
provide you with the best possible radio reception.
You can find out more about the SRC-System™ from your
specialist dealer and at schubertnorthamerica.com/us
We recommend that you only use original SCHUBERTH accessories
and spare parts for your SCHUBERTH helmet as they are specially
adapted to your helmet model.
integrated antennas for optimal
radio reception
Plug for connection with the
SRC-System™
Bluetooth
®
antenna
4. ORDERING ORIGINAL SCHUBERTH PARTS
Please contact your Schuberth dealer or Intersport Fashion West,
Inc., if you need replacement parts.
I. ACCESSORIES AND SPARE PARTS
englishenglish
To Next Page
Loading...
