59
«PLEASE START AGAIN»
l If the door was closed subsequently, the start but›
ton must be pressed again.
l After a power failure you must press the start button
to continue the programme.
If the machine shows a function fault F :
u Stop the programme with the Quick Wash button
and select a new programme.
In the event of repeated error messages:
u Disconnect the electricity for approx. 1 minute and
then switch on again. (Withdraw the mains plug or
switch
off the main building switch.)
u The machine is ready to operate once again when
the programme pilot lamps flash.
u Select a new programme.
If the error message still appears:
u Make a note of the error message
u Switch off the water tap and withdraw the mains
plug or switch off the main building switch.
u Inform Customer Service.
Troubleshooting
Other minor faults, which you can rectify yourself.
Machine operation
Display is dark:
u The machine is in standby mode. No error. To ope›
rate the machine press any key.
The machine cannot be switched on, display remains
dark even after pressing a key:
u Check whether the mains power is switched on at
the wall and the plug is in.
u Check whether all the fuses are intact or the safety
switch has tripped.
u Mains blockage, generally at noon. Operate the
machine after the mains blockage has ended.
The machine does not start:
u The start button has not been pressed.
u Start time preselect has been set. Only starts at the
preselected start time.
Loading door cannot be opened:
u Programme not yet finished.
u «Rinsing stop» selected. No error; see chapter
«Washing/Ending the programme with rinsing stop».
u Mains blockage or appliance defect: see below.
Open the door in the event of a power failure or appli›
ance defect as follows:
u Turn off the water tap
u
Switch off the mains power supply.
u Remove the rubber grommet to the left of the door
lock. Insert a screwdriver and press down.
l The loading door opens.
Check that the drum has come to a standstill, before
reaching into it!e Trommel stillsteht, bevor Sie in die
Trommel greifen!
Power failure :
u After a power failure the programme will start auto›
matically or if you press the start button (according to
the settings of the machine parameters). It will restart
from the point at which the power failure occurred.
u Disinfection programmes must be executed anew
from the very start.
To Next Page
