1 Safety instructions
In addition to the safety instructions provided in the installation instructions and in the operating
instructions, the following safety instructions are to be followed:
Repairs may only be carried out by trained and qualified specialists.
Defective components may only be replaced with original spare parts by the original equipment
manufacturer.
Disconnect machine from the mains, before removing the covers (top cover, side covers, back
covers, heating covers, door covers, etc.).
In cases of works on machines on which a cover was removed without having disconnected the
machine from the mains first, there is a risk of electric shocks.
Even with switched-off machines, there may remain electrical residual voltages. There is a risk of
electric shocks.
In addition to the risk of electric shocks, there is a risk that a uncontrolled retraction movement of
the arm or hand is triggered by the electric shock, which then in turn may result in cuts on sharp-
edged components. Due to this retraction movement, it may also be possible to get into rotating
components or running drive belts.
Moreover, there is a risk of injuries resulting from mechanical (sharp-edged, springy or rotating
components, running drive belts) and thermal effects (hot detergents and hot components).
Those who work in the areas surrounding sharp-edged components have to wear protective
gloves. Furthermore, sharp edges are to be covered with cloth or adhesive tape.
Even if the drum is only manually set in rotation, there is a risk of fingers being trapped in the
pulley’s belt.
For transportation, the machine must be lifted by auxiliary means, since there is otherwise a risk
of back injuries as well as a risk of hands and feet being trapped.
To Next Page
Loading...
