Troubleshooting
14 01.00 | IN / INK | Assembly and Operating Manual | en | 1596635
Possible cause Sources of interference Corrective action
The sensor is influenced by a
different sensor.
Same or similar product Increase the distance
between the sensors to at
least 2 mm.
The sensor is affected by
deposits of magnetic shavings
in the vicinity (in the air gap).
Liquids with magnetic particles
or the like.
Regularly clean the
immediate environment of
the sensor. The higher the
exposure to such fluids, the
more often it needs to be
cleaned.
NOTE
If these steps do not eliminate the problem, contact SCHUNK
Service for troubleshooting.
To Next Page
Loading...