SCHUNK RH 918 - Page 9

Translation of original EC declaration of incorporation
01/RH918-9010/2006-42-EC/de-en/2009-12-17/SW
EC declaration of incorporation
In terms of the EC Machinery Directive 2006/42/EC, annex II B
Manufacturer/
distributor
SCHUNK GmbH & Co. KG.
Spann- und Greiftechnik
Bahnhofstr. 106 – 134
74348 Lauffen/Neckar, Germany
We hereby declare that the following product:
Product designation
2-Finger Parallel Gripper
Type designation:
RH 918, RH 9010
ID number:
0360140, 0360141
meets the applicable basic requirements of the Directive Machinery (2006/42/EC).
The incomplete machine may not be put into operation until conformity of the machine into which the
incomplete machine is to be installed with the provisions of the Machinery Directive (2006/42/EC) is
confirmed.
Applied harmonized standards, especially:
EN ISO 12100-1
Safety of machines - Basic concepts, general principles for design -- Part 1:
Basic terminology, methodology
EN ISO 12100-2
Safety of machines - Basic concepts, general principles for design -- Part 2:
Technical principles
The manufacturer agrees to forward on demand the special technical documents for the incomplete
machine to state offices.
The special technical documents according to Annex VII, Part B, belonging to the incomplete
machine have been created.
Person responsible for documentation: Mr. Michael Eckert, Tel.: +49(0)7133/103-2204
Location, date/signature:
Lauffen, Germany,
January 2010
p.p.
Title of the signatory
Director for Development