Pre-set programs
Program 1: Gate control 1
Both channels work with the same frequency and pulse width.
Frequency: 100 Hz
Pulse width: 200 µs
Therapy time: 30 min (10 to 90 min)
Indications: Acute nerve or joint pain
This program is used to treat acute
neuropathic and joint pain. The eect is
immediate.
Program 2: Gate control 2
Both channels work with the same frequency and pulse width
(see illustration Program 1).
Frequency: 80 Hz
Pulse width: 150 µs
Therapy time: 30 min (10 to 90 min)
Indications: Acute nerve or joint pain
Program 2 is similar to program 1 but works with a lower frequency and may therefore
be considered as more pleasant.
Program 3: Low frequency
Both channels work with the same frequency and pulse width
(see illustration Program 1).
Frequency: 2 Hz
Pulse width: 250 µs
Therapy time: 30 min (10 to 90 min)
Indications: Diuse nerve, joint or muscle pain, spasms, lower back pain, neck pain,
fibromyalgia, chronic pain. This program is used to relax painful muscles and to achieve
an endorphin release. Endorphins have an analgesic eect that lasts beyond stimulation,
but you need to run program P3 to the end (30 min). To achieve particularly good eects
use kaada electrodes placement (on the hand).
To Next Page
Loading...
