76
Operation
SP 500 / 750-15 / 750-18 / 1000 / 1250 Operation Manual
6. The Receiver LED Display will ash Po-Id.
7. Turn o the power to the Receiver by shutting o
the engine. Remove the pairing plug from the re-
ceiver socket. Restart the truck engine to power
up the Receiver. The Transmitter has now been
paired to the Receiver.
If pairing is performed during low bat-
tery on the Transmitter it may look
like the paring works but it does not.
This is related to a safety precaution.
Replace battery and repeat the par-
ing procedure.
To Next Page
Loading...